Note: with firmware and configuration based on “MultiWii” software, the processor used is not Atmel AVR, and can not be compiled via Arduino or other AVR tools. If you are using cleanflight firmware, please refer to the below link to download and install cleanflight Configurator: This manual is a baseflight Setup Tuning Guide for SKYLINE32.

SKYLINE32 is loaded with baseflight and Baseflight-Configurator GUI. Note: SKYLINE32 hardware is compatible with NAZE32 firmware, including cleanflight, baseflight. GPS position hold / “Go home” function(GPS Optional). Parameters adjustment interface: Baseflight-Configuration. Click on the Flash Firmware button and hold still (do not breathe, too). Ensure the correct serial port is selected. Connect the flight controller board to the PC. If this is the first time Cleanflight is flashed to the board, tick the Full Chip Erase checkbox. Micro-USB: Flashing firmware & adjusting parameter When upgrading review all release notes since your current firmware. Flexible RC input: standard, CPPM (PPM SUM) Cleanflight comes with a detailed manual that is reviewed and maintained by the Cleanflight developers and community. Support Quad-,Tri-,Hex- ,various multirotors. Manual mode, Angle mode, Horizon mode, heading hold mode, head-free mode, Altitude hold mode (this mode is available in advanced version) With gyro, compass, extended reservation position for accelerometer, barometer. 32-bit ARM micro processor running at 3.3V / 72MHZ. Adapting high quality electronic components & high precision SMT. Thin and light design, reducing overall weight saving mounting space! Unique wire-to-board connectors, makes wiring easier! (SKYLINE32 is loaded with Baseflight-Configurator) Being open-source means that you too can contribute to the system. The CLI can be accessed via the GUI tool or via a terminal emulator connected to the CLI serial port. The skyline32 runs the open-source Cleanflight flight control (FC) software which has an ever-growing community of friendly developers and users. Cleanflight has a command line interface (CLI) that can be used to change settings and configure the FC.

Skylline 32 cleanflight firmware